N O T E T H E A R R O W S – F o r t h e c r a d l e t o f i t p r o p e r l y , g r i n d t h i s a r e a m o r e t h a n t h e p h o t o i n d i c a t e s .
8.
(SEE UPDATE ABOVE FOR STEP 8)
To properly check the fit of the cradle in your new support –
CAREFULLY
remove the very small screws located at the bottom of the cradle. BE
CAREFUL with the circuit board too. NOTE:
THIS STEP SHOULD HAVE
BEEN DONE EARLIER BUT WAS LEFT HERE AS A “HOW TO”
9. Once apart, take the shell (the part with Dension imprinted) to the ashtray and
check for fit and closure.
10. For the ashtray to open and close properly –
(once the cradle is reassembled (later)) with
the plug -- you have to trim the edge
underneath the ashtray lid. The edge is about
a 1/16” and runs the width of the lid.
11. GO SLOWLY!
To perform this procedure I
used a Dremel tool with a cut off attachment
and the console as a brace. Also, a good shop
light is a must!
Summary of Contents for ice-Link: Plus
Page 6: ...MISC PHOTOS...
Page 15: ...Miscellaneous Photos...
