Dension ice-Link: Plus, Installation Manual

21. With the center console raised about 

three inches – Drill a hole in the b
of the enclosure right beneath where 
the cord comes out of the cradle.  Your 
hole should be centered and toward
the rear seat but still on the bottom n
the side of the enclosure.  RAISING 
THE CONSOLE WHILE DRILLING
ENSURES YOU DON’T DAMAGE 
ANY WIRES/ AIR DUCT, ETC.  

NOTE – Photo shows the hole a little smaller than it actually needs to be. 

ottom 

s 

ot 

22. Make the hole large enough for the 

l 

g 

23. Once you have the connector and some wire through the hole in the ashtray enclosure try grabbing and gently 

connector to come through. You wil
have to raise the console while pushin
the connector through. TAKE YOUR TIME this part can be a little frustrating. 

pulling it through the access hole for the phone wiring harness (SEE PHOTO BELOW – BLUE ARROW). 
Once you have it to this point STOP and remove the rear ac vents if not already done. (See BMWTIPS.COM
for vent removal help) 

With the console up 3 inches (RED ARROW) you should have no problems grabbing the connector 

and (SLOWLY) pulling the remaining wire through this hole (BLUE ARROW).