- 116 -
ading Pa
The setup menu for the scanner reading parameters is launched from the System
Properties or the Test menu in the System menu.
se the settings
: Enables or disables the menu.
Default is unchecked (disabled).
er reading mode.
able codes.
ata Edit
: Edits data read by the scanner.
K
button:
Exits
the
menu.
The new settings takes effect after the
OK
button is
6.10.1. Read Mode
omentary:
Momentary
switching
mode
lternate:
Alternate
switching
mode
ontinuous:
Continuous
reading
mode
eeper:
Activates the beeper and or vibrator when the
scanning is completed.
a code is read.
on continu
turns off a
illum
When a first code is read successfully
r reads a code.
In order to read the next code, read ou
data from the code buffer, then press the trigger key again.
Momentary switching mode:
Only while the trigger key is held down, the illumination LED turns on and the BHT can read a code.
The illumination LED does not turn back on by pressing the trigger key thus, the BHT does not read the next
code, unless the scanned data is read out from the barcode buffer.
rameters
6.10. Scanner Re
u
Read Mode
: Sets the scann
Read Code
: Sets up the read
D
O
pressed, and are stored in the registry.
Cancel
button: Aborts the changes and exits the menu.
The Read Mode menu is used to set the scanner reading mode.
Select one from the following 4 modes.
Auto Off:
Auto-Off
mode
M
A
C
B
Auto-off mode
The illumination LED turns on when the trigger key is pressed, and turns off when the trigger key is released or
ously for a maximum of 5 seconds while the trigger key is pressed.
fter 5 seconds has elapsed, press the trigger key again.
ination LED is turned on.
the code device file is closed, the BHT no longe
or
t the scanned
The illumination LED turns
When the illumination LED
The BHT reads a code while the
