- 48 -
6.4. System Properties
The System Properties is used to set up various settings that control how the BHT works.
The System Properties is accessible from both the BHTShell in the desktop and the BHTSettings in the Control
Panel.
6.4.1. Scanner settings
Double tap the
Scanner
icon in the System Properties to set up how the BHT reads
barcodes or QRcodes.
The scanner menu varies depending on the BHT Series models.
Scanner menu for BHT-1300B Series
[1]INVERT
Enables or disables inverted barcodes to be read.
[2]DECODE LEVEL Selects the decode level.
[3]ITF
Selects the minimum number of digits for ITF as a
default.
[4]STF
Selects the minimum number of digits for STF as a
default.
[5]CODABAR
Selects the minimum number of digits for CODABAR as
a default.
[6]Read Parameter Launch the menu for barcode reading parameter.
Refer to “6.10 Scanner Reading Parameters” for details
[1] INVERT (Black-and-white inverted code reading function)
Standard barcodes are black bars on white backgrounds.
Set to ON to enable inverted barcodes to be read.
Default is set to OFF.
Note
Setting the INVERT to ON may increase the frequency of barcode read errors.
Setting the INVERT to OFF is recommended if not necessary. (Inverted barcode
reading is disabled).
[2] DECODE LEVEL
The decode level is selectable from 1 to 9. The default level is set to 4.
Lowering the level increases the barcode reading efficiency, however, misreading probability of poor-quality
barcodes (broken or dirty bars) also increases. Raising the level decreases the barcode reading efficiency, and
also decreases misreading probability of poor-quality barcodes.
System Properties
