Quick
Start
Check the
Active
box, and the system is now configured to automatically download IP
addresses, software, and configuration files to the terminals. Click on the box in the
upper right corner to return to the main menu.
Note:
The software does not need to be authorized now. It can be authorized later, after a
Telnet session has been established. The procedure is described in the section of
this chapter entitled
Authorizing PowerNet
.
Booting the Terminal
At any time it is necessary to update the terminal software and/or configuration, the
terminal must be cold-booted. Instructions on performing a cold boot (also known as a
hard reset) and on performing a warm boot (also known as a soft reset) are as follows.
Warm boot:
Press the
Reset
button on the side of the terminal.
Cold boot:
Press the
Reset
button while holding the
Power
key.
Supported Equipment Manual
•
May, 2006
2-11
