Standard
Setup
Key Click
This check box enables (checked) or disables (unchecked) audible key clicks from the
terminal. The default value is
on
(checked).
Printer Type
This scrolling list selects the attached printer type. The default value is
none
,
indicating
that no printer is attached.
Terminal Setup Using Twin Client Menus
The Twin Client terminal software provides an internal menu system for configuring
certain parameters on the terminal and for switching between Server and Telnet modes of
operation. To access this menu system, press uppercase
C
at the startup screen as shown
in the following figure.
Twin Client
© 1991-2006, Connect, Inc.
Keypress to continue
Note:
The date of 2006 is updated on the terminal at the time of a new release.
The following menu appears in thick (Telnet) mode:
Edit Server/Host IPs
Edit License Key
Switch Client Modes
Run Client Emulator
Exit to OS
The following menu appears in thin (Server) mode:
Edit Server/Host IPs
Run Site Survey
Switch Client Modes
Run Client Emulator
Exit to OS
Use the
Up-Arrow
and
Down-Arrow
keys to navigate the menu, and press
Enter
to select
the highlighted option. Each menu option is described below.
Edit Server/Host IPs
If the host IP address(es) were not pre-configured as described in the Setting the Servers
section of
Configuring the Manager
, or if you wish to change those settings using the
terminal menus, select this option and enter up to four Host IP addresses as required.
Supported Equipment Manual
•
May, 2006
2-19
