32
5-5
．
．
．
．
Setting Other Parameters
Trigger switch control
You may choose the trigger switch control mode from the
following five:
(1) Auto-off mode
Pressing the trigger switch makes the scanner ready to scan
for five seconds. If the code reading is completed successfully
or five seconds pass, then the scanner will automatically return
to the standby mode.
(2) Momentary switching mode
Only while you hold down the trigger switch, the scanner can
read a bar code. Releasing the trigger switch will return the
scanner to the standby mode.
(3) Alternate switching mode
Pressing the trigger switch toggles between the ready-to-scan
mode and standby mode.
(4) Repeat mode
Turning on the scanner immediately makes it ready to scan
and keeps it in the ready-to-scan mode. Even if the code
reading is completed, you may read the same code repeatedly
by pressing the trigger switch by the required number of times,
provided that the reading window remains in contact with that
bar code and the indicator LED lights in green.
(5) Continuous reading mode
Turning on the scanner immediately makes it ready to scan
and keeps it in the ready-to-scan mode. No trigger switch
operation is required. Note: If you turn on the scanner with the
reading window applied to a bar code, the scanner cannot read
the bar code. To read the code, pull the reading window away
from the bar code and then bring it back to the code again.
≪
Auto-off mode
≫
Momentary switching mode
Alternate switching mode
Repeat mode
Continuous reading mode
