52
Chapter 4 Creating a Project
2.
Follow the wizard's instructions to configure the project.
There are six items to specify in the case of manual robot type selection.
1) Project name and location
2) Robot type
3) Robot controller options
4) Link type
5) Variables
6) I/O port settings
In the case of project creation from controller information, make settings only for 1) Project name and lo-
cation, and 4) Link type
Note
• The last four can be modified at any time, but not the first three:
• Project name and location
• Robot type
• Robot controller options
• There is a basic setting that specifies where WINCAPS III saves new projects. For further details
on these settings, please refer to 3.1.1 "WINCAPS III basic settings" (P. 14).
• Do not check the Customer specifications check box displayed by Robot controller options for
standard robots. Use for robots with special specifications (with a "#" for the robot type).
3.
When a Complete button appears on the screen, press it to display the new project.
Summary of Contents for WINCAPS III
