Dentsply Sirona
Operating Instructions DAC Universal
6 Errors / Display messages
6.3 Error messages as pop-up messages
6681006 D3708
D3708.201.01.01.02 04.2019
113
The symbol appears that the cycle has been discontinued, an alarm
signals and the LED flashes.
If a process error message appears during the reprocessing cycle, the
lid opens and moves up.
There is a tick/confirmation function key to confirm that the error
message has been acknowledged.
If there are several error messages at the same time, only one is
shown. After the first is displayed, the next message is displayed. There
is no specific sequence for this. The message can be confirmed, which
switches off the alarm and then the homescreen is displayed again.
There is no additional window for all error messages that have resulted
in the reprocessing cycles being canceled.
After confirming the message(s), you are automatically taken to the
homescreen.
There are 8 kinds of process error messages:
● No compressed air
● Water tank is not inserted in the DAC Universal
● Poor water quality
● No oil (there is no oil in the lubrication concentrate bottle or a
lubrication concentrate bottle is missing)
● Service needed. Please check the operating instructions or contact
your authorized dealer.
● The process was personally discontinued.
● A new lid has been inserted into the DAC Universal.
6.3
Error messages as pop-up messages
04:00 PM
1002
The messages only appear outside a reprocessing cycle. They appear
as a pop-up message but without the symbol that the cycle can be
canceled, no acoustic alarm will sound and the LED will not light up.
The error message covers the "
Start reprocessing cycle“ function key
There are 4 kinds of error messages as pop-up messages:
● Please contact your authorized dealer.
● Safety ring was pressed
● No compressed air
● Front flap on the water tank is still open
All error messages are displayed, as soon as the message has been
confirmed the homescreen appears again.
Exception:
04:00 PM
The error message shown here appears if the "
Cancel" function key is
pressed during an ongoing reprocessing cycle. The DAC Universal
shows this message to confirm whether you really want to cancel the
cycle or have canceled the cycle accidentally.
