each floor loop tightly outwards from the center.
5. Put the 4 sections of the center pole together.
6. Unzip the door and screen and walk into the tent with the pole.
a. Push the center pole into the peak of the tent and carefully bring the
bottom of the pole to the approximate center of the floor.
NOTE: Pole should be as vertical as possible. Once pole is in location, it should
hole the tent upright while you perform the following steps)
7. Assemble the door frame and use the Velcro loops to secure it into place on the
inside of the tent.
8. Upon first set up, secure the ropes through the eave grommets and loop a
tensioner to the opposite end.
9. Secure each rope to the ground with a stake, again by pulling from the center
outwards in a star pattern. Repeat until all stakes are in the ground.
10.Tension each rope so the tent is pulled into shape.
Note: If ropes are not tensioning the tent properly or if the tent is not shaped as
desired, try re-tensioning the rope/s or remove the stake/s and adjust the rope to
a better location.
Revision B
2
|
Page
Summary of Contents for The Colorado Tent Maroon Bell
Page 4: ...Revision B 4 Page...
Page 6: ...Revision B 6 Page...