TO LISTEN TO PRESET STATIONS
1. Set your desired frequency to be ready as a PRESET STATION.
2. Press the MEMORY button to enter PRESET SETUP MODE.
3. P01 will blink and press again the MEMORY button to set the current frequency as P01.
4. Repeat step 2 and step 3 until PRESET stations from P01 to P10 is setup.
5. Press the PRESET button listen to preset station P01.
6. Press again the PRESET button to move on to preset station P02, and do the same to reach
other preset stations.
7. To change the preset stations repeat the steps above
8. To restore default setup eliminate the power source of the device.
BATTERY BACK-UP
Your clock has a battery back up feature in case of power failure. 2 AAA batteries (not included)
is required. You must put in the batteries to ensure the battery back up feature is ready in case
of power failure. If power fails, the back up battery will automatically continue operation of the
clock and maintain actual time. However, the display will not be lighted. During actual power
failure the alarm function will not be operational. When electrical power is restored, the display
will light up again and alarm time set previously is restored. The battery will maintain timekeeping
for approximately 8 hours during power failure or interruption.
Note
: Remove the battery if the clock is to be unplugged for a long time avoid unnecessary
battery drain.
ENG-5
