BEFORE PLAYBACK
HOLD switch
Release the HOLD switch to OFF position
before playback.
When not using the unit, set the HOLD switch
to the ON position, Accidentally pressed button
will not function, If buttons are pressed when
the HOLD switch is set to the ON position.
"HOLD" will light on the display.
Turn on and off
Turn the power on
Press PLAY/PAUSE. Power is turned on
and playback starts.
Turning off the power
If no new operations are done within 30 seconds
from the end of last operation, the power is
turned off automatically.(Auto power off
function) you can turn off the power before it is
automatically turned off by pressing STOP
Standby mode
When an operation finishes, the unit goes into
standby mode until the auto power off function
automatically turns off the power.
To enter standby mode, press PLAY/PAUSE
to start playback, then press STOP
Adjusting the sound
Volume
Turn The VOLUME control to adjust the volume.
BASS BOOST
Switch on the BASS BOOST for extra bass
emphasized.
Inserting a disc
1. Push the OPEN switch to open the disc
compartment.
2. Place a disc in the center with the label side
facing up.
3.Close the disc compartment.
To remove the disc
Pick up the disc, holding its edge, while
pressing the pivot gently.
D
D
D
E
E
F
G
3
D
E
F
G
HOLD
VOLUME
BBS
