DENVER MT-100
Quick Start Guide
1.
TURN ON:
Turn DISCRIMINATION knob until red LED lights shortly up and then set to
MIN
2.
TUNE:
Keep holding RED button down and at the same time rotate TUNE knob until the
dial in the display is set at “0” (Yellow part of display)
3.
HOW TO USE:
Move slowly in sideways motions close over ground until display dial
shows reading (either to left/red side or to right/green side)
4.
READING TO LEFT/RED COLOR SIDE OF DISPLAY (AND NO SOUND)
means smaller
iron article (ferrous) (for example iron nail).
5.
READING TO RIGHT/GREEN COLOR SIDE OF DISPLAY (AND SOUND)
means other
metal (could be coin or gold ring) but can also be big iron article (ferrous). You need to dig
up to see what it is.
6.
IMPORTANT:
You have to use RED color button to reset TUNE to “0” after each reading!
(keep the round disc close to ground and where there is no metal)
7.
CAUTION:
Before starting to use the metal detector please take most care not to use the
metal detector in any area which might contain dangerous items such as explosives from
a war or power cables or gas lines or any other dangerous items.”
