3.
Insert the latch on top of the handle into the assembly hole at
the bottom of the control box. Slightly push the control box in
the direction of the “IN” marking on the handle to fix the latch in
place.
4.
Tighten the fixing screw.
5.
Insert the search coil cable plug into
the five pin jack on the back of the
control box housing.
6.
Lengthen or shorten the shaft, so when you stand upright with
the metal detector in your hand, the search coil is level with and
about 0.5 to 2 inches (1 to 5 cm) above the ground. Then
tighten the lock nut.
Caution:
Lock nut
Fixing screw
Control box
Latch
Assembly hole
