The search coil cable plug fits into the connector only one way.
DO NOT
insert the plug forcefully to avoid damaging it.
DO NOT
remove the shaft lock nut. Should you remove it,
place the washer on top of the shaft connected to the handle
with the small head of the washer pointing up. Then place the
shaft lock nut on the washer and tighten it to lock it in place.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the end of the search coil and adjust the search
coil to the desired angle (the search coil should be parallel with the
ground). Tighten the knobs just enough to keep the search coil from
rotating or wobbling.
INSTALLING THE BATTERIES
You need two 9 V alkaline batteries to power your metal detector.
Small head
