¼ò ½é
¼ò ½é
SETUP
6
Remote Control Battery Installation
4. If you cause a static discharge when touching the unit, and the unit fails to function, simply unplug the
unit from the AC outlet, wait a few minutes, and plug it back in. The unit should return to normal operation.
Requires two AAA batteries(supplied).
Procedure
1. Turn the remote control face down. Remove battery cover by pressing down on the marking on the
cover and sliding it off in the direction indicated.
2. Install batteries ma) and(-) polarity signs.
3. Replace the battery cover by sliding in reverse until the lock snaps.
Note: Incorrect installation can cause battery leakage and corrosion that will damage the Remote control.
Precautions
Replace batteries in pair.
Do not mix battery types(zinc carbon with alkaline).
Do not recharge, heat, short-circuit, disassemble, or burn batteries.
To turn the TV power ON
Put the TV set on the correct place, then connect the DC plug of the AC-DC adaptor to the DC 12V socket
at the back of the TV set. Connect the adaptor main cord to the wall outlet ,then the LED indicator lamp
turns red/green and the TV set is at Standby/work Mode. At Standby Mode, if Standby Button is pressed
the power indicator will change to green. It takes a few seconds before the picture appears.
To turn the TV power OFF
Press the Standby Button to make the TV set in Standby Mode, then disconnect the power plug from the
wall outlet.
FUNCTIONAL PARTS(TV)
Front View of LCD Set
NOTE
If TV is the selected input without
signal received and NO operation
is performed for about 5 minutes
continuously, the TV set will enter
standby mode. For any inputs other
than TV, the TV set will not enter
standby mode automatically without
users instruction. If you are not
going to use this TV set for a long
time, switch off the set and
disconnect the power plug from
the wall outlet.
2. Remote Sensor
1. LED indicator lamp
3. Standby Button
4. SOURCE Button
5. MENU Button
6. P+ Button
7. P- Button
8. V+Button
9. V- Button
9
8
7
6
5
4
1
¼ò ½é
¼ò ½é
3
2
