9
3 Installation
·
Blow out air line and pressure hose, prior to connection it to the tool.
·
Make sure, that all air lines have a sufficient cross-section (see technical
data) and hoses must be free of bends and kinks. The hose length should
not exceed 2 meters.
·
All DEPRAG Screwdrivers, may be operated either with or without
lubricated air (see paragraph: Maintenance and Upkeep). Best results are
achieved, when machine is lubricated with 1 – 2 drops of oil per 1m
3
.
When operating with oilfree air, a performance reduction of up to 20%
occurs and maintenance requirements increases!
·
Connect the equipment as follows:
a) for standard operation connect equipment to a maintenance unit,
consisting of Filter with condensation reservoir, Regulator and Oiler.
When choosing a maintenance unit, observe air consumption rate for
the tool (see Technical Data).
Air Consumption Thread Size
Part No.
0,05 - 0,5 m³/min
¼”
820454 A
0,15 – 1,5 m³/min
½”
820455 A
0,8 – 6,0 m³/min
¾”
821608 A
b) for the use with minimal lubrication connect to a filter-regulator
consisting of Filter with condensation reservoir and pressure regulator
Air Consumption Thread Size
Part No.
0,05 - 0,5 m³/min
¼”
822408 A
0,15 – 0,9 m³/min
3
¤
8
”
826981 A
0,5 – 1,5 m³/min
½”
822409 A
0,8 – 6,0 m³/min
¾”
826982 A
Each in connection with a Point-of-Use Oiler (Part No. 378077 A)
c) for oilfree operation, connect to Filter/Regulator, consisting of Filter
with condensation reservoir and Pressure Regulator.
Air Consumption Thread Size
Part No.
0,05 - 0,5 m³/min
¼”
822408 A
0,15 – 0,9 m³/min
3
¤
8
”
826981 A
0,5 – 1,5 m³/min
½”
822409 A
0,8 – 6,0 m³/min
¾”
826982 A
Summary of Contents for 397075 A
