Se�ngs
12 / 20
Derksen Lich�echnik
•
Switch on the projector
5.3. Aligning the projector head
1.
Loosen the countersunk screw.
2.
Tilt the projector head into the desired posi�on.
(Note: There is a mechanical stop to limit the projector
head’s rota�on and prevent damage to the
cable. Do not �lt or rotate the projector head without
previously loosening the countersunk screw.)
3.
Tighten the countersunk screw.
5.4. Adjus�ng the focus of the mo�f
1.
Loosen the knurled screw.
2. Reposi�on the projec�on lens within the case un�l
the mo�f is in focus.
3.
Tighten the knurled screw.
5.2. Aligning the projector
1.
Turn the projector into the desired posi�on.
(Note: There is a mechanical stop to limit the rota�on
of the device stand and prevent damage to the cable.)
WARNING! Risk of burns!
You can burn yourself on projector parts which have become hot.
▶
Let the device cool for at least 10 minutes before any set-up work.
WARNING! Op�cal radia�on hazard!
Op�cal radia�on can cause temporary or permanent eye damage.
▶
Never stare directly into the beam of light.
