1.
Ensure that the power track has no voltage.
2.
The adapter has a bar 3 mm in height on one side,
which has a counterpart in the power track and there-
fore requires precise alignment.
Moun�ng
8 / 20
Derksen Lich�echnik
Moun�ng
8 / 20
Derksen Lich�echnik
4. Moun�ng and installa�on
•
Your new LED projector must be securely installed before you start using it. A track ligh�ng adapter that meets the
specifica�ons ensures secure fi�ng.
•
Ensure that the suppor�ng structure can handle this load. It must be able to carry at least four �mes the expected load.
If other projectors or devices are used on your track, please consider the total weight of all the devices. Informa�on
about the weight of your device is provided in the technical specifica�ons.
•
Select the fixing materials based on the load, the nature of the support material and the fire and building regula�ons.
4.1. Overview of the track ligh�ng
adapter
4.2. Moun�ng the projector
When you fit the PHOS LT to your power track, you should also connect the projector to the power supply at the same
�me. In the case of a mul�-phase track system, the adapter of the PHOS LT allows a free choice of the phase.
To make things clearer, the track ligh�ng adapter is shown without the device stand in some cases in the following instruc-
�ons.
1
2
3
4
①
Cable opening and connec�on sleeve
②
Rotary switch for phase selec�on
③
Locking lever for fixing into the power
track
④
Contacts for electrical connec�on
WARNING! Danger of electric shock!
An electric shock can cause serious injury or death.
▶
Only install the device once the mains supply has been switched off.
