Aesthetic Technology Limited
8
9
PL-027 (Rev 7)
PL-027 (Rev 7)
1. Unpack and assemble the device as per PL-028 Assembly Guide found in Section
19 of the User Guide.
2. Once the Flex MD is unpacked, assembled and connected to a mains
socket, switch on the mains switch, then press the power button on the
Controller (Power button will illuminate in green).
Name
Icon
Description
Power
Blue
Red
Turns device on and off.
Activates Blue LED’s for treatment.
Activates Red LED’s for treatment.
NIR
Activates Near Infra-Red LED’s
for treatment.
Control Buttons
BLUE
RED
NIR
Play
Initiates 30 minute treatment with
pre-selected LED wavelengths.
Table 1: Flex MD Control Buttons.
3.
Upon activation, the timer screen will display the Dermalux® logo, followed by the
Flex MD logo.
Select the required combination of wavelengths by pressing the buttons on the right
side of the Controller. See Flex MD Treatment Protocol Chart (PL-025)
4.
When the required wavelengths have been selected, press the PLAY button.
The PLAY button will then change from red to green to indicate that the treatment
has started. If the treatment is paused it will revert to a red light until resumed.
Figure 2: Flex MD Controller.
