www.dero.com | 1-888-337-6729
© 2018 Dero
CYCLE STATION
Installation Instructions
Install the purlins with (4) 3/8” x 5.5” bolts, (4)
washers, (4) lock washers, and (4) nuts each. Fully
tighten all purlins.
For shelters with side panels, install the front
and side panel supports between every upright,
except where the door will be installed. Align
slots in the panel support with the slots in the
upright, drill 3/8” diameter holes, and fasten with
3/8” wedge anchors with nuts finger-tight.
For polycarbonate panels, install the panels
with (4) 8mm bolts and (4) lock washers. (2)
130mm bolts on top and (2) 65mm bolts on the
bottom. The bolts will be received by square
nuts that slide into the panel grooves. The
gap on top of the panel will be filled with (2)
1.25” aluminum spacers and several washers if
needed. The uprights and panel supports may
be slightly moved in order to get the panels as
square as possible.
For wire mesh panels, install the panels with (4)
5/16” bolts and (4) lock washers. (2) 5.5” bolts
on top and (2) 3” bolts on the bottom. The bolts
will be received by rivet nuts in the panels. The
gap on top of the panel will be filled with (2)
1.25” aluminum spacers and several washers if
needed.
For shelters with Dero Decker racks, install
the DD beams with (8) 5/8” x 2” carriage bolts,
(8) lock washers, and (8) nuts each. Leave
finger-tight. Carriage bolts at the end of the
shelter should have the heads facing out. See
shelter assembly drawing for specific DD beam
placement locations.
5
7
8
6
