1. Power On/Off
2. Volume
3. Set-A and Set-B
Searching Best Frequency: Press “SET--
▲
” key for 1 second to search the best operating
channel (frequency)
Auto Matching: Press “SET--
▼
-
”
key for 1 second, put the transmitter ASC aim to the
receiver ASC window, transmit the channel index to transmitter, it may automatically matching the
channel between receiver and transmitter.
press “
▲” or “▼”in 3 second to change the selected channel, press “SET-
▼”key for 1 second again to match the transmitter (we don’t prefer to change the
channel in this way)
4. ASC window
5. LCD display: Channel number, RF level, AF level, Mute, Frequency
6. Antenna
7. Audio balanced output
8. Squelch and noise mute adjusting button. Adjusting range is 0-40dB.
9. Audio Unbalanced output
10.Power Jack: connecting a 12v DC 50/60Hz adaptor for power.
LCD of receiver
U-6298
U-6198
1. 8-level RF display: to display the RF level
2. 8-level AF display: to display the AF level
3. Frequency display: when FREQ lighting, the last 6 figure means the working frequency.
4. Channel Display: when CHAN lighting, it display the working channel.
5. Channel or Frequency display. It shows the working channel or frequency.
6. MUTE display: MUTE lighting means the system hasn’t receive the RF signal.
Receiver Operating
1. Turn Off the transmitter, Turn the Volume to “low”.
2. Turn on the receiver, check the RF and AF level, if interference too large, change the channel to
avoid any interference .
3. Turn on the transmitter, the working RF-level display lighting, turn the volume to suitable level, then
speak, the AF-level display working according to your voice.
4. Take off the power switch when finish using.
--3--
Auto searching Channel
1. Set-up the left Channel (Set.A)
Press “SET--
▲
” key for 1 second, the display shows the system is automatically searching the best
workable frequency (channel). (Picture 1).
Infrared matching channel
Put the transmitter’s ASC sensor close to the receiver’s ASC sensor, press “SET--
▼
” key for 1
seconds, it will automatically transmit the channel index to the transmitter (microphone)----(Picture
2)
After the 1
st
and 2
nd
steps fnished, the handheld microphone (transmitter) LED light,means working.
U-6298
U-6198
2. Set-up the right channel (Set.B)
Set-up the right channel (Set.B) in same steps.
When the microphone and receiver shows same channels, the system is workable.(Pic. 3)
Remarks: press “
▲” or “▼” in 3 seconds to change the working channel. (we
don’t prefer to change the channel in this way)
-
-4-
