107434-01C
For more information, visit www.desatech.com
For more information, visit www.desatech.com
10
Black
Powercord
Wire
Figure 13 - Removing Wires from Blower
Screw
Green
Ground Wire
White
Powercord
Wire
O
F
F
P
IL
O
T
O
N
H
I
L
O
INSTALLATION
Continued
Figure 11 - Removing Stove Top Panel
Figure 14 - Removing Blower Brackets from Stove and Attaching
to Blower
Blower
Blower
Bracket
Firebox Top
Top Trim
Screws
Top Panel
Screws
Screws
INSTALLING OPTIONAL BLOWER
ACCESSORY GA3750
Tools required: Phillips screwdriver
NOTICE: Shut off gas heater during the following blower
installation.
1.
Remove 2 screws from rear tabs on top trim. Pull trim forward
to remove (see Figure 11).
2.
Remove top panel of stove by removing three screws from
under top lip on each side of stove (see Figure 11).
3.
Facing front of stove, carefully slide top panel forward until it
is completely removed from stove (see Figure 11).
4.
Install one plastic bushing provided in blower kit into the 1
1
/
2
"
hole in the left rear of firebox floor. Access hole through the
rectangular opening in the rear panel (see Figure 12).
5.
Disconnect power cord wires from blower motor (if connected)
(see Figure 13).
6.
Disconnect green ground wire from blower housing (if connected)
by removing screw holding wire terminal (see Figure 13).
7.
Remove the two blower mounting brackets from the rear panel
by removing two screws each (see Figure 14).
8.
Attach the two mounting brackets to blower housing using four
screws provided in blower kit (2 for each bracket) (see Figure
14). Tighten screws securely. Place blower assembly tempo-
rarily on top of firebox.
9.
Working from the rear of the stove, place entire power cord,
including speed control housing, in lower control compartment.
10. Route ends of 3-wire power cord up from the lower control com-
partment through the plastic bushing, then up to the upper cavity
of stove (see Figure 15, page 11).
11. Attach the terminal ends of the white and black power cord
wires to the terminals on the blower motor (see Figure 12).
Push firmly.
12. Attach the terminal end of the green power cord wire to the front
tab of the blower housing using screw provided (see Figure 13).
Screws
Figure 12 - Installing Bushing
Bushing
INSTALLATION
Installing Optional Blower Accessory GA3750
