6
100170
INSTALLATION
Hose
Regulator
Vent
(pointing down)
POL Fitting
Supply
Valve
Propane
Tank
1. Provide propane supply system (see Propane Supply, page 5).
2. Connect POL fitting on hose/regulator assembly to propane tank(s). Turn POL
fitting counterclockwise into threads on tank. Tighten firmly using
2.22 cm (7/8in.) wrench.
IMPORTANT:
Tighten regulator with vent pointing
down. Pointing vent down protects regulator from weather damage.
WARNING
Review and understand the warnings in the Safety Information
Section, page 3. They are needed to safely operate this heater.
Follow all local codes when using this heater.
WARNING
Test all gas piping and connections for leaks after installing
or servicing. Never use an open flame to check for a leak.
Apply a mixture of liquid soap and water to all joints. Bubbles
forming show a leak. Correct all leaks at once.
Figure 3 - Regulator With Vent Pointing Down
3. Connect hose to inlet connector. Tighten firmly using a wrench.
IMPORTANT:
Extra hose or piping may be used if needed. Install extra hose
or piping between hose/regulator assembly and propane tank. You must use
the regulator supplied with heater.
Figure 4 - Hose and Inlet Connector
Hose
Inlet Connector
