www.desatech.com
123502-01C
18
INSTALLING LOG SET AND
SCREEN (vDCF MODELS)
1. Remove log packaging material and
discard packaging. Gently place log over
burner (see Figure 27). Do not allow log to
contact flame. If flame contacts log, soot
will be created.
2. Reattach screen by placing notches in
screen frame over shoulder screws and
pushing down.
iNsTallaTioN
Continued
Log
Shoulder
Screw
Screen
Figure 27 - Installing Log and Screen
INSTALLING bRICK LINERS AND
LOG SET AND SCREEN (CDCF
MODELS)
1. Remove packaging from brick liners previ-
ously removed from behind top louver.
Figure 28 - Installing Rear Brick Liner
Figure 29 - Installing Side Brick Liners
Figure 30 - Installing Log
Left Brick
Liner
Brick Liner
Bracket and
Screw
Rear Brick
Liner
Log Set
2. Place rear brick liner against back of fire
-
box. The left and right brick liners will hold
this liner in place (see Figure 28). Be sure
to hold the rear brick liner while installing
the sides so it will not fall forward.
3. Install left and right brick liners using
brackets and screws from hardware kit
as shown in Figure 29. Screw the bracket
into top of firebox and against brick liners.
Adjust bracket before tightening screw.
4. Remove log packaging material and dis-
card. Gently place log over burner (see
Figure 30). (Do not allow log to contact
flame as this will create sooting.)