5. Squeeze trigger to fire.
6.
IMPORTANT:
Do not fire this tool
when empty of staples. This may
damage tool.
Note:
In difficult fastening jobs, press
down on head of tool with palm of
free hand (see Figure 6). This will
improve staple driving.
Tool Jam
1. If tool jams, move trigger lock to the OFF position and unplug tool.
2. Turn tool upside down.
3. Press in latch lock and slide staple chamber cover back until fully open.
4. Remove unused staples.
5. Remove staple(s) causing jam.
6. Reload tool (see Loading Tool, page 5).
Cleaning
Use a clean cloth to remove dirt from tool. Do not use solvents when cleaning
plastic parts.
Lubrication
Do not oil or grease any part of tool. This may damage tool.
IMPORTANT:
Do not attempt to repair tool or replace broken parts. Any
servicing, except what is listed above, should be done by an our factory service
center.
Figure 6
Maintenance
!
WARNING ICON
G 001
WARNING: Do not alter this tool in any way. Only use accessories
designed for this tool.
!
WARNING ICON
G 001
WARNING: Never perform steps listed below while tool is plugged
in. Accidental discharge may occur. Move trigger lock to the OFF
position and unplug tool.
