Desco SCS 992X-0350, Instruction Manual

8.

Operating the Product

8-1

Setup before Starting Operation

Check the ionizer wiring and air tubing.
Supply air to the unit from the air equipment that is used.

Use air pressure off 0.5MPa or less.

Supply DC24V power to the unit. The POWER LED and RUN 

LED on the unit illuminate and electrostatic elimination starts.

If  the  optional  power  adapter  is  used,  supply  AC100-240V, 

50/60Hz

8-2

Steps when Stopping Operation

8-3

Canceling the Alarm

Because this device utilizes high voltage, if a safety or operating 

problem is detected, the high voltage is shut off. At this time the 
RUN LED turns OFF and the ALARM LED illuminates. The system 
is configured so that the system cannot be restarted unit the alarm 
has been reset.

When the ALARM LED is illuminated, refer to “9.

Troubleshooting” in this manual and correct the problem before 
restarting operation.

© 2016 DESCO INDUSTRIES INC.

Employee Owned      

DESCO JAPAN    
TB-9052    Page 16 of 20   May 2016   

Remove power source.
Remove air supply.

Remove power source, correct problem per troubleshooting guide in 
Section 9 and then restore power supply.

Remove power source.

Correct problem per troubleshooting guide in Section 9 and then restore 
power supply.