5
INSTALLATION (TYPE A)
- Insert one of exiting keys to the cylinder and mark it
5
mm from the surface of cylinder.
- Take out the key and saw o the head of the key fom marked line. You may need some tools like vice, hacksaw etc. Use a
rasp to smooth the edges. DESi accepts no liability for damages.
- Insert modified key to cylinder and verify that it is cut in a proper way.
- Install the motorized knob on the cylinder where
the arrrows on the key slot point upward
and the modified key is in
the position that
it can be taken out from the cylinder without rotating
(could be either horizontal or vertical.)
- First tighten 4 fixing screws lightly, then tighten them firm.
Follow the steps below to install motorized knob to the existing cylinder:
5
mm
Cut the key.
Keep the modified key in
the position that it can be
taken out. Don’t rotate!
Install the motorized knob
on the cylinder. The arrows on
the key slot should point upward.
Tighten the 4 fixing
screws.
MODIFIED KEY
MODIFIED KEY