Installing beacons in the lane
8
© DESIGNA Verkehrsleittechnik GmbH
13
DESIGNA SMART MOVE_Installation_110_ENG.docx
8.1.1 Installing the beacon box on the entrance /exit control terminal
The beacon is housed in a plastic box and installed on the side of the
device facing the barrier.
Power is supplied by the device.
Fig. 5:
Beacon box on device
Holes on the entrance /exit
control terminal
1.
Drill three holes in the device
(see figure below):
Two holes for installation on the device
One hole for the cable duct
Fig. 6:
Beacon box installation on entrance /exit control terminal– holes
(dimensions in mm)
2.
Open the beacon box to screw the box to the device.