11
Rev 07/04/2015
1.2.
FAILURE CODE DETAILS
The HACCP feature provides the ability to get additional information such as
failure code, date of occurrence, min/max temperature (if applicable), and
duration of alarm condition. To access previous failure codes, press and hold
the PROGRAM key for 5 seconds.
Use the UP and DOWN arrow keys to scroll
PROGRAM key to exit.
1.3.
SERVICE MENU
1.3.1 Entering the configurat
The service menu can be accessed only during OFF mode.
Press the up/down keys
together for 5 seconds to enter the menu.
controller doesn’t need actually any password to
the up arrow key the parameter list can be accessed directly
the parameter by pressing Up/do
Change the value by up/down keys. Pr
1.3.2 Parameter list
The following table shows parameter factory settings for both Blast
and Shock Freezers (GBF).
NOTE: Selecting a freezing cycle on a GBC unit
(Cabinet at 0°C, needle probe end cycle temperature at 3°C)
Blast ch
FAILURE CODE DETAILS
The HACCP feature provides the ability to get additional information such as
failure code, date of occurrence, min/max temperature (if applicable), and
To access previous failure codes, press and hold
the PROGRAM key for 5 seconds.
Use the UP and DOWN arrow keys to scroll through the previous failure codes. Press the
SERVICE MENU – CONFIGURATION PARAMETER
configuration parameter
The service menu can be accessed only during OFF mode.
for 5 seconds to enter the menu. Label PA (password) will be shown as first
controller doesn’t need actually any password to configure the parameters. By pressing
the up arrow key the parameter list can be accessed directly (first parameter is P0).
the parameter by pressing Up/down keys. Select a parameter by pressing
Change the value by up/down keys. Press again time key to save and go back to the list.
ist (factory setting)
The following table shows parameter factory settings for both Blast
Selecting a freezing cycle on a GBC unit will run a normal chilling cycle
(Cabinet at 0°C, needle probe end cycle temperature at 3°C)
Blast chiller Service Manual
The HACCP feature provides the ability to get additional information such as
failure code, date of occurrence, min/max temperature (if applicable), and
To access previous failure codes, press and hold
through the previous failure codes. Press the
PARAMETER
will be shown as first. The
configure the parameters. By pressing
(first parameter is P0). Scroll
parameter by pressing the time key
to save and go back to the list.
The following table shows parameter factory settings for both Blast chillers units (GBC)
will run a normal chilling cycle
Summary of Contents for GBC-15
