461933
Issue no : 08
Series : C
11/2016
19 / 64
MAINTENANCE INSTRUCTIONS
The bearing sleeve complete is under
spring (20) compression. whilst
resisting the thrust due to the spring
(20), carefully unscrew and remove
the bearing sleeve complete followed
by the spring.
●
Service should be carried out at intervals of
1000 hours’use. Always quote tool model
number, serial number and spare part
number when ordering spares.
● All torque figures ± 5%.
●
Dismantle the tool using the exploded view.
●
Clean all components and inspect for wear or
damage, exchange if necessary.
●
Apply new lubricant to the relevant parts in
accordance with list.
●
Replace the front seal after dismantling the
tool.
●
Special tools shown in exploded view are in
addition to normal workshop tools.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
Protective gloves and eye protection
should be worn during cleaning of parts.
Eating or smoking is prohibited when
cleaning, dismantling or assembling tool.
