Operation
EN
14 / 24
01/2020
Operation
Configuration Instructions
How to communicate with CONNECT
Connect the tool as described previously.
Refer to the
Product Instructions
of CONNECT available at
https://www.desouttertools.com/resource-centre
How to communicate with CVI3 Vision
Connect the tool as described previously.
Refer to the
Installation and upgrade manual
of CVI3 System available at
https://www.desouttertools.com/
.
Refer to the
Configuration manual
of CVI3 tightening controllers available at
https://www.desouttertools.com/
.
How to use the tool in the stand-alone working mode
How to change the working mode
To activate the screens, you need to have a CVIKEY USB stick with the right profile (configured with the Desoutter
CVIKEY software).
If not, contact your CVIKEY manager for support.
Changing the tool working mode will erase the Pset, the results and curves present in the tool memory.
Plug the eDOCK to the tool and connect it to the USB port of the computer where CVI MONITOR is installed.
Go to the CVI3 launch bar on your desktop.
Launch CVI MONITOR.
Click
Tool
.
Click
Select
.
Summary of Contents for EABS12-1100-10S
Page 13: ...EN Installation 01 2020 13 24 Installing the EABS front suspension swiveling bail ...
Page 22: ......
Page 23: ......