Operation
EN
8 / 16
12/2020
Operation
Configuration Instructions
How to get information about the tool
Connect the tool to XPB Config.
Go to the tab
Tool configuration
.
The following information is displayed.
• Desoutter serial number
• Tool firmware version
• Battery level
• Number of drilling cycles executed (
Counter
) since the manufacturing date.
Customize the following information:
Customer serial number
Up to 16 characters
Tool description
Up to 32 characters
Click this button to update the tool.
Unplug and plug the battery pack to validate new settings in the tool.
How to configure the tool
How to manage the white LED intensity
Connect the tool to XPB Config.
Go to the tab
Tool configuration
.
Go to the box
White LED level
.
Select the intensity of the white LED in percentage.
Click this button to update the tool.
Unplug and plug the battery pack to validate new settings in the tool.
How to prevent the tool to start when battery pack level too low
Connect the tool to XPB Config.
Go to the tab
Tool configuration
.
Go to the box
Maintenance
.
Select the minimum load level (0% by default) at which the tool will not start.
Click this button to update the tool.
Unplug and plug the battery pack to validate new settings in the tool.
How to lock the tool when counter is reached
Connect the tool to XPB Config.
Go to the tab
Tool configuration
.
Go to the box
Maintenance
.
In the box
Counter limit
, enter the number of drilling cycles to reach (from 0 to 1,000,000).
Tick
Lock tool
.
Click this button to update the tool.
Unplug and plug the battery pack to validate new settings in the tool.
How to manage the counter of the cutting tool
Connect the tool to XPB Config.
Go to the tab
Head and Psets configuration
.
