E105, 313327, REV A
Protocol 3
TM
User Guide
24 of 82
©2021 ITW EAE. All rights reserved. Despatch is a registered trademark in the U.S. and other
countries.
No part of the contents of this manual may be reproduced, copied or transmitted in any form
or by any means without the written permission from ITW EAE, unless for purchaser's personal use.
3.
Refer to Section 5.3.2 (
Protocol 3™
Ethernet Port MAC Address) for more
information on retrieving the MAC address.
On the Protocol 3 control, remove the back plate to access the circuit board
area of the control and record the MAC address listed on the Ethernet
communications card on the board of the control. There are two screws
holding the plate in place which can be removed with a T10 Torx bit. Refer
to Figure 4 and Figure 5.
Figure 4.
Protocol 3™ rear cover removed
Figure 5
. Protocol 3™ Ethernet module MAC address
4.
From the Windows Start menu, navigate to the
Graphical Controller Tools
menu and run
Graphical Controller Ethernet Setup
.
