Despatch/Watlow 1500 Control Instruction Manual
Page 19
Step
FUNCTION
Display
Programming Procedure
Channel 1
Set Point
S1
1.
2.
Select the Channel 1 set point.
Press
ENTER
(or
FCTN
to leave blank).
Channel 2
Set Point
S2
1.
2.
Select the Channel 2 set point.
Press
ENTER
(or
FCTN
to leave blank).
Channel 1
Event
Outputs
E1
1.
2.
Select a 1 or a 0 for each of the four available events
(1 = ON, 0 = OFF). The
DATA
display shows the 1 or 0
entry for Events 4* through 1, from left to right.
Press
ENTER
(or
FCTN
to leave blank).
Channel 2
Event
Outputs
E2
1.
2.
Select a 1 or a 0 for each of the four available events
(1 = ON, 0 = OFF). The
DATA
display shows the 1 or 0
entry for Events 4* through 1, from left to right.
Press
ENTER
.
NOTE:
If you've set DIP Switch #1 ON, then there are only three events
available for each channel. In that case each Event 4 is an
alarm.
Step
Duration
HR
1.
2.
3.
4.
5.
6.
Select hours.
Press
ENTER
. The prompt MN will appear.
Select minutes, press
ENTER
. The prompt
SC
will appear.
Select seconds.
Press
ENTER
. The step duration in hours, minutes and
seconds will appear in the
FUNCTION
and
DATA
displays.
The
TIME
LED will be ON.
Press
FCTN
to proceed to the next prompt,
NX
.
Next Step
NX
To display the next prompt in sequence, press
ENTER
.
To display a different step:
1.
2.
Enter that step number with the
>
and
?
keys.
Press
ENTER
. The Watlow 1500 will return to the SP, JL,
WT, NX loop. The process begins over again.
Table 7 Set Point Step Programming Detail
Creating Files/Profiles (Cont.)
