En.a4
MMT4X6O man
ENGLISH
STEP 3
Insert the two M14 x 95 mm bolts from inside through the springs, nuts, washers and
fender L-brackets, then tighten just until spring is secure. Do not over-tighten, since the
brackets will need adjustment to the fenders later and it may collapse spring channel.
Place the tongue tube between the two drawbar reinforcment brackets by using
M14 x
85 mm bolts
.
Install the coupler and safety chains using the M10 x 80 mm bolts
and M10 lock nuts
provided.
The front bolt passes though the end link of the safety chain as it is inserted through
the tongue tubes. Tighten both bolts.
