En.m4
MMT5X7G man
English
tRAILeR COUpLeR
A = Locked
B = Unlocked
To adjust coupler to ball;
Set coupler and tongue on to the 2” trailer ball on your vehicle.
Raise the locking lever, push up on channel lock and turn nut to tighten or loosen the coupler.
Proper adjustment is obtained when coupler is as tight as possible on the ball and locking lever can still be opened and
closed.
Before towing your trailer be sure to check the capacity of your trailer hitch on your vehicle (never exceed this or
your trailers capacity).
The Detail K2 Trailer is equipped with a 2” coupler and must be used with a 2” trailer ball. Make
sure that the trailer ball is completely engaged in the coupler ball
WHeeL BeARINg & HUB ASSeMBLY
NOTE: Bearings should be re-packed every 2000 miles or 3200 kilometers.
no parts arE morE CritiCal for thE DEpEnDablE pErformanCE of Your trailEr
than thE bEarings, raCEs, anD sEals. to EnsurE that Your trailEr pErforms
rEliablY, You shoulD inspECt thE bEarings, raCEs, anD sEals anD rEpaCK thE
bEarings EvErY 12 months or 2000 mi. (3200 km). this is EasilY founD on thE
intErnEt bY sEarChing “trailEr whEEl bEarings maintEnanCE”
A
B
Item #
Description
Qty.
1
1” Axle Bearing Kit
1
1A
Bearing Cup (press fi t)
2
1B
1” Bearing Cone
2
1C
Grease Seal
1
1D
2” Axle Dust Cap
1
Item #
Description
Qty.
1E
1” Axle Castle Nut
1
1F
3/16” Cotter Pin
1
2
Hub (bare) with bearing race
1
3
Axle c/w hubs and bearings
1
Part # _____ Axle Bearing Kit includes all parts 1A to 1E.
Note: Part 1A Bearing Race is press fi t into the Hub and may not need to be replaced when changing bearings.
