DS7080iP-32 Reference Guide Copyright © 2001 Detection Systems, Inc. P/N 39818D Page 39
9.42 Address 083 - 116 - Alpha Labels
Hint:
To get an Address Location
for a zone number, use the
following:
Zone # + 84 = Address #
Examples:
Zone 9 + 84 = Address 093
Zone 20 + 84 = Address 104
Address 083 - Partition 1 Label
Address 084 - Partition 2 Label
Address 085 - Zone 1 Alpha Label
Address 086 - Zone 2 Alpha Label
Address 087 - Zone 3 Alpha Label
Address 088 - Zone 4 Alpha Label
Address 089 - Zone 5 Alpha Label
Address 090 - Zone 6 Alpha Label
Address 091 - Zone 7 Alpha Label
Address 092 - Zone 8 Alpha Label
Armed
Status
Power
Fire
7
8
9
0
*
#
On
No
Entry
Bypass
Ready To Arm
ABC Alarm
Partition Label
SPACE
1 , "
& / # !
2 A B C
3 D E F
4 G H I
5 J K L
6 M N O
8 T U V
7 P R S
9 W X Y
0 Q Z
Move Cursor Left
Move Cursor Right
Don't Accept
(Hold for 2
seconds to exit)
Accept Value
UPPER/lower
case toggle
4
5
6
1
2
3
System
Reset
Only
Perimeter
Off
Example:
To program “ABC Alarm” as the Private Label for Partition 1
Enter the Programmer’s Mode:
[[9] [8] [7] [6] [#] [0] (or [9] [8] [7] [6] [5] [4] [#] [0] if six digit codes are selected)
Enter the Program Address:
[0] [8] [3] followed by [#]
Enter:
[2] for the letter “A” then press the right arrow key to continue with the next letter
Enter:
[2] twice for the letter “B” the press the right arrow key for the next letter
Enter:
[2] three times for the letter “C” then press the right arrow key for the next letter
Enter:
[1] until you have a blank space (Note: Moving the cursor to the left does not create
a space. Spaces must be programmed into the Alpha using the [1] key)
Enter:
[2] for the letter “A” then press the right arrow key for the next letter
Enter:
[System Reset] The “System Reset” key is the UPPER/lower case toggle
Enter:
[5] three times for the letter “l” then press the right arrow key for the next letter
Enter:
[2] for the letter “a” then press the right arrow key for the next letter
Enter:
[7] twice for the letter “r” then press the right arrow key for the next letter
Enter:
[6] for the letter “m”
Enter:
[#] Program the next address, program a different address or exit the
Programmer’s Mode.
9.43 Address 117 - Point Expansion Module Missing Report
9.44 Address 118 - Point Expansion Module Missing Restoral Report
