8
M100-ADSL Interface DSL Modem
Installation Guide
Installation of the Interface Card (this figure: OpenCom130)
3. Carefully insert the interface card
in the slot:
– OpenCom 130: slot
no. 3
.
– OpenCom 150: slot
no. 3
,
no. 4
or
no. 5
.
The component side must face to
the right. Ensure that the card is
fitted securely.
4. Connect the interface card to the
DSL splitter with the connector
cable supplied. Plug one end of the
cable into the RJ45 socket on the
interface card, and the other end
into the RJ45 socket on the DSL
splitter.
Please note:
In order to reduce the
tension on the RJ45 socket, you should
never lead the connection cable loosely
out of the housing. Always secure the
cable to the housing, e.g. by using the
cable ties supplied to fasten the cable to
one of the recesses or ribs running along
the lower edge of the housing.
5. Close the housing cover.
Turn on the OpenCom 100.
RJ45 jack
Type (name) of
the interface card
