MARK TAILPIECE HERE
CUT THIS SIDE OF MARK
Fig. T2A
Fig. T2B
8. At the outside trim cam hole "d", measure up 1/4" and make a new mark. This will be the
center of the outside trim cylinder. Center punch and drill a 1-1/2" hole. Repeat for inside of
door.
ASSEMBLING THE OUTSIDE TRIM AND BACKPLATE:
1. Place the trim assembly against the door, aligning the cylinder tailpiece through the backplate
trim cam.
2. Mark the tailpiece as it protrudes through the cam (see Fig. T2A).
3. Remove trim assembly and cut the tailpiece just inside of the mark (see Fig. T2B).
Caution:
Tailpiece must not extend past the cam.
Page 3
