104948 Page 10
40-3/8"
38"
Align rod holes with bottom latch
(round
DIM A
to nearest value shown)
DIM A
(device C at
distance from floor )
L
39"
40"
Bottom Rod
p/n: 105098
use HOLE
40-3/4"
X
Y
Z
V
W
BOTTOM ROD
p/n 105098
BOTTOM BOLT
p/n 103536-1
NOTE: SLOTS
MUST
BE IN
POSITION SHOWN
(SCREWS AT THE TOP)
DURING ADJUSTMENT
Adjust length here
1/2" MINIMUM
thread engagement
required
DIM C
V
W
X
Y
Z
HORIZONTAL DEVICE
INNER FACE OF
DOOR SHOWN
BOTTOM OF DOOR
FINISHED FLOOR
DIM A
5a.
Using
DIM A
as measured in step 1,
use chart to determine pinning location.
If
DIM A
is
less
than 37-1/4" from finished floor, a new pin hole must
be drilled through 105098 rod. Subtract the centerline dimension from
38" and measure up this distance from hole V.
Mark and drill .189 diameter hole (#12 drill).
If
DIM A
is
more
than 41-1/2", from floor, call customer service
at 1-800-729-3839 for assistance.
Note: If hole V or W is used (or if new hole is drilled closer to threaded end),
trim off UNTHREADED end of rod as needed to allow rod to slide into bottom
bolt far enough to pin.
5b.
DIM C
is the target length.
For no threshold or threshold 1/2" or less:
DIM C
= measured
DIM A
minus 8".
For threshold greater than 1/2":
DIM C
= measured
DIM A
minus 8" minus threshold height
The bottom bolt vertical travel from fully extended to fully retracted
is approximately 9/16.
5c
. Thread bottom rod into centerlift mechansim to achieve
DIM C
(within 1/16").
ROD
P/N 105098
STEP 5:
BOTTOM ROD / LATCH ASSEMBLY & ADJUSTMENT
(Disregard if TRO device is being installed)
5a
5c
5b
SPRING PIN
p/n 101607
