STEP 5:
VISUAL ALIGNMENT CHECK:
Latch must be in
RETRACTED position
5a.
Lay internal latch components onto
door for trial fit. Take care to
protect door finish.
5b.
Ensure top latch is in retracted
position. Hold top rod in place and
push top latch case towards
device until latchbolt is fully
retracted.
5c.
Mounting holes for centerlift should
line up with mounting holes in
door, and top and bottom latches
should be in position shown. If not,
go back to steps 3 & 4 and verify
rod length dimensions.
C
L
5a
5b
5c
3/8" from top of door
to latch body
DEVICE
HORIZONTAL
C
L
104924 Page 11