65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56/820027, Fax: +359 56/836700
E-mail: office@devabroadcast.com
Web: www.devabroadcast.com
- 23 -
FTP SERVER SETTINGS
Access to the built-in FTP server is controlled by applying Username and Password with
maximum length of 6 symbols each of them. It must be noted that the FTP Server works in Passive
mode and it is necessary a Wide Area Network (WAN) address to be specified.
If DB8000 is connected directly to the computer where the FTP Client is installed then the
WAN IP Address must be equal to that of IP Address in Sub-menu
6.Network Settings
(WAN IP address = IP address). Direct DB8000 connection is illustrated below:
FTP CLIENT
DB8000
WAN IP
If a networking device (router for example) is used, then the DB8000 WAN IP Address must be
equal to that of the router as illustrated below:
DB8000
WAN IP
ROUTER
WAN IP
=
NETWORK
FTP CLIENT
Command and Data Ports are the other two parameters that must be specified in order to
establish FTP connection.
NOTE:
As the DB8000’s FTP server can manage only one connection at a certain time, please
configure your FTP client to use only one simultaneous connection.
Configuration of the FTP Server can be accomplished following the next steps:
1. While in the Main Menu press the
OK
button;
2. Press the
DOWN
key and select Sub-menu
7.FTP Server Settings
.
3. Press the
OK
button. The
DOWN
key can be used to navigate through this Sub-menu which
looks like below: