Page 1
Page 6
Installation
Installation
Installation
Installation
Prior to installation you should fully flush the system to ensure there is no debris in the system
that could cause damage to the product.
Installation should be carried out by a competent installer who after installation should check for
leaks on both the product and the pipe work.
The product must be installed and used in a way as to not cause water damage. Therefore water
from the product must be suitably directed and/or contained.
Sensor Adjustment
Sensor Adjustment
Sensor Adjustment
Sensor Adjustment
Sensor Adjustment
Sensor Adjustment
Sensor Adjustment
Sensor Adjustment
The sensor beam length can be adjusted.
To do this the sensor light panel must be removed from the mixer body.
Once removed a screw is located on the rear of the sensor panel, this can be turned to adjust the
sensor beam length.
Turn the screw clockwise to shorten the beam length.
Replace the sensor panel and ensure correclty located.
Operation
Operation
Operation
Operation
Place hand in front of sensor panel to operate, this will allow water to flow.
To mix temperature turn handle on side of mixer to increase or decrease water temeprature.
DTC INST190 - 23.9.11