Page 3
Page 4
Fitting instructions
Fitting instructions
Fitting instructions
Fitting instructions
Step 1
Step 1
Step 1
Step 1
Ensure that base o ring is fitted
into the groove in the base plate.
Screw tails into connections in base
of mixer until tight.
Once fitted, then place the tail
through the hole in the basin.
Step 2
Step 2
Step 2
Step 2
Once the mixer has been pushed through the hole,
from the underside, push the rubber washer over
tail, follwed by the metal washer.
The connect the back nut onto the tail and screw this
to the underside of the basin.
Position the mixer correctly then tighten the back nut
until the mixer is secure, to provide additional
stability, tighten the two screws fitted in the back
nut.
Step 3
Step 3
Step 3
Step 3
Remove the mixer cap, by removing the grub
screw in the rear of the mixer, inside is located
the battery pack.
Remove the top of the pack by removing the
screw, the insert the batteries.
Once fitted replace the pack cap and tighten
screw, then repalce the mixer cap and re-fit
grub screw.
Step 6
Step 6
Step 6
Step 6
Connect tails to water supply, hot to
left, cold to right.
Your mixer is now ready to use,
check the sensor by placing
your hand in front of the
sensor, if this does not work,
check that the batteries have
been fitted correctly
DTC INST190 - 23.9.11