User's Guide
- 118 -
Universal Setup menu
Use
To
Units of Measure
Inches
Millimeters
Identify the units of measure.
Note:
Millimeters is the factory default setting.
Portrait Width
3–8.5 inches
76–216 mm
Set the portrait width.
Notes:
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
•
You can increase the width in 0.01-inch increments.
•
216 mm is the factory default setting. You can increase the width
in 1-mm increments.
Portrait Height
3–14.17 inches
76–360 mm
Set the portrait height.
Notes:
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
•
You can increase the height in 0.01-inch increments.
•
356 mm is the factory default setting. You can increase the height
in 1-mm increments.
Feed Direction
Short Edge
Long Edge
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.
Summary of Contents for ineo 3320
Page 1: ...User s Guide ineo 3320 ...