A
Small leak at nasal pillows:
1. Repeat steps 4(B) and 4(C).
2. Gently tighten the overhead strap on the
headgear.
STEP 6 - Adjusting for Leakage after Applying Air
Pressure
Nasal pillows are not maintaining adequate
contact with your nose:
1. Place pillows in tall position as shown
in step 3(B).
2. Repeat steps 4 and 5.
B
Small leak at oral cushion:
1. Lift the interface slightly off the face
and reposition.
2. Repeat steps 4(B) and 5(B). Do not
over-tighten headgear straps as this
may create discomfort.
C
Gently press interface towards face and
push one of the lower quick release
buckles forward until it unsnaps. Pull
interface and headgear away from head.
STEP 7 - Removing the Interface
NOTE: If you are unable to resolve leaks, you may need to try one
of the alternative nasal pillow or oral cushion sizes included in your
Hybrid interface package.
TIP:
Although the swiveling elbow on the Hybrid
allows you to route the CPAP hose in all direc-
tions, the quietest experience will occur when the
CPAP hose is routed in the downward direction.
Remember, the Keys to a Good Fit with the Hybrid are:
Proper oral cushion size
Proper nasal pillow size
Appropriate pillow height position
Upper seal of cushion completely above mouth on the upper lip
Headgear worn correctly
Adjust four side straps similarly for an even, balanced fit
Adjust the overhead strap on the headgear
!
For further fitting instructions, please reference the Fitting Tips video located on the product CD.
© 2013 DeVilbiss Healthcare LLC. 02.13 All Rights Reserved.
DeVilbiss
®
is a registered trademark of DeVilbiss Healthcare. Hybrid™ is a trademark of InnoMed Technologies, Inc. and RespCare, Inc.
LT-2110 Rev. B
