2
© 2007 ITW Finishing Systems and Products
EC Declaration of Conformity
We:
ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK
, as the
manufacturer of the
Spraygun model JGA
, declare, under our sole responsibility, that the
equipment to which this document relates is in conformity with the following standards or other
normative documents:
BS EN 292-1 PARTS 1 & 2: 1991, BS EN 1953: 1999;
and thereby conform to the
protection requirements of Council Directive
98/37/EEC
relating to
Machinery Safety
Directive
,
and;
EN
13463-1:2001,
council Directive
94/9/EC
relating to
Equipment and Protective
Systems intended for use in Potentially Explosive Atmospheres
protection level
II 2 G X
.
E
E
Model Part Number
Example:
JGA-558FWH-797
Fluid Tip Size
Aircap No
Gun Number
Operation Manual
JGA – Pressure Feed Spraygun
Important
Read and follow all instructions and Safety Precautions before using
this equipment
Description
The JGA Pressure Feed Spraygun Kit is approved to ATEX regulations
94/9/EC
, protection level;
II 2 G X Suitable for use in Zones 1, and 2
Important:
These Sprayguns are suitable for use with most solvent based coating materials.
Nozzles and Needles are manufactured in Stainless Steel. These guns are not designed for use
with highly corrosive and/or abrasive materials and if used with such materials it must be
expected that the need for cleaning and/or replacement of parts will be increased. If there is any
doubt regarding the suitability of a specific material contact your local Distributor or ITW Finishing
direct.
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
B. Holt,
General Manager
30th June 2003