Page 12 SB-2-226-B
Air Cap Seal
To replace air cap seal, pry out old seal
with a small thin bladed screwdriver. With
air cap in retaining ring place the seal on
outer edge of ring. Use your finger and
thumb to push the seal into retaining ring
and slip it in place by sliding your finger
around the ring, Figure 22.
Figure 22
Fluid Head Retaining Ring
1 .
Cut the old head retaining ring (15)
using wire cutter, and remove from
the gun body.
2.
Remove and discard the retaining
ring clip (16).
3.
Position the new retaining ring clip
over the retaining ring groove in the
head end of the skeleton, Figure 23.
4 .
Close the clip with one hand, then
push the retaining ring back until it
slides over the clip and snaps in
place. When properly secured, the
head retaining ring is captive and
cannot be pulled off the skeleton.
Figure 23
Air Cap
Retaining
Ring
Seal
Head
Retaining
Ring
Groove
Retaining
Ring
Clip
