page 19
Manual_Revised_V1.1
2) Insert the SDS drill bit into the tool holder with
a turning motion until it automatically locks;
3) Check the locking effect by pulling the SDS
drill bit.
To remove the SDS drill bit
,
Push the locking
sleeve toward the rear and pull out the bit.
8. Forward/reverse adjustment
For forward (clockwise) rotation, push the
forward /reverse switch to the left position.
For reverse (counterclockwise) rotation, push
the forward/reverse switch to the right position
as shown. Although an interlock prevents
reversing the tool while the motor is running,
allow it to come to a full stop before reversing.
If forward/reverse switch is on the central position,
the tool cannot be switched on.
9. LED worklight
The tool has an LED light to illuminate the work
area and improve vision when working in areas
with insufficient light. The LED light will switch
on automatically while the trigger switch is
depressed.
If the LED worklight begins to rapidly and
continuously flash when the switch on the tool is
depressed, the battery-pack power has run out,
and the battery pack should be recharged.
10. Start cordless hammer
Squeeze the trigger switch to start the tool. And
allow the tool reaches full speed before beginning
drilling.
After completing your drilling, release the trigger
switch, allow the bit to come to a complete stop
before setting the tool down.
This tool has a variable speed switch that delivers
higher speed and torque with increased trigger
pressure. Speed is controlled by the amount of
switch trigger depression.
The variable speed feature is particularly useful
when driving screws. It also enables you to select
the best speed for a particular application.
NOTE:
It is recommended to use the variable
speed feature for a short time only. Do not
continuously operate the tool at different speeds.
It may damage the switch.
WARNING:
Please start the tool for 2-3
minutes first before use, while the temperature is
below zero and there is no impact phenomenon
after you turn on the tool.
Summary of Contents for 5401-Li-20RH
